![]() Under Display, click Change Resolution.If the NVIDIA Control Panel is not listed, update the graphics drivers. ![]() Right-click the Shadow desktop, then click NVIDIA Control Panel.Check our Other Tips for changing the resolution and refresh rate.įollow these instructions to choose from a list of resolution and refresh rate options in the NVIDIA Control Panel.If your resolution is higher than 1080p, choose a 60Hz refresh rate.Do not exceed your screen's resolution or refresh rate.When choosing your resolution and refresh rate, keep the following in mind:.A recent NVIDIA update may cause issues when creating a custom resolution in Shadow.V: height 1050 start 10 total 1089 clock 60. H: width 1680 start 17 total 2240 skew 0 clock 65.3KHz HDMI-0 connected primary 1920x1080+0+0 (normal left inverted right x axis y axis) 509mm x 286mmġ920x1080 60.0*+ 59.9 50.0 60.1 60.0 50.0ĭP-0 disconnected (normal left inverted right x axis y axis)ĭVI-D-0 disconnected (normal left inverted right x axis y axis)ĭP-1 disconnected (normal left inverted right x axis y axis) Screen 0: minimum 8 x 8, current 3280 x 1080, maximum 16384 x 16384ĭVI-I-0 connected 1360x768+1920+211 (normal left inverted right x axis y axis) 0mm x 0mmĭVI-I-1 disconnected (normal left inverted right x axis y axis) Other information here: Nvidia driver version is 346. Running the nouveau drivers help my problem somewhat (At least I can access terminals with them), but I still can't select proper resolutions. Pressing CTRL+ ALT+ F1 only leads to a blinking cursor, no login prompt, and the same goes for all other terminals CTRL+ ALT+ F2 to CTRL+ ALT+ F6 ![]() The only shown resolutions for my display are the ones I had previously, I can't select any new resolution.Īlso: I can't see any terminals when both monitors are plugged in. I tried adding the above code to /etc/X11/nf - but that didn't help either. I ended up with this 10-monitor file in my /usr/share/X11/ directory: Section "Monitor" I did so by following Enabling Resolutions in Ubuntu 12.04 & Lubuntu 12.04. Searching for this particular problem isn't much help at all, but I was lead to try to edit my nf file. Minor opcode of failed request: 18 (RRAddOutputMode)Ĭurrent serial number in output stream: 42 Major opcode of failed request: 140 (RANDR) ![]() Xrandr -addmode DVI-I-0 "1680x1050_60.00"īut I get this error: X Error of failed request: BadMatch (invalid parameter attributes) I know that's a supported resolution, because it's the one I use in Windows 7. My Nvidia card and Ubuntu detects the monitor no problem, but I can't choose the max resolution 1680 x 1050. I have a second monitor plugged in by a DVI to VGA converter. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |